Translators-Home
PDS2KPIPE
PDMS2KPIPE
CATIA2KPIPE
Tribon2KPIPE
Cadmatic2KPIPE
User Comments
{"We use CAEPIPE to design the process coils in our steam cracking furnaces. These coils operate at temperatures between 1,200°F & 2,000°F. Supports must be sized properly to prevent coil distortion and rapid failure. CAEPIPE graphic displays are extremely useful in determining if we have input the geometry correctly and in evaluation of results." }
Arthur DiNicolantonio, Exxon, CAEPIPE user for over 12 years
{"The new graphics rendering feature [in CAEPIPE v5.x] is fantastic. It far exceeds the graphics of any other piping stress analysis program I have seen."}
Ed Patnode, Advanced Thermal, CAEPIPE user for over 10 years
CATIA2CAEPIPE™, the Plant Design-to-CAEPIPE Interface, is a stand-alone program for transferring pipe geometry including section properties from Dassault’s CATIA software to SST’s Pipe Stress Analysis software CAEPIPE, by extracting information from the Piping Module (PIP 2). Tubing module is not yet supported.
PD2CAEPIPE Interface converts the 3D piping model from the PCF file generated by CATIA. A PCF file can be extracted after setting up the configuration as given in this file.
The execution sequence is as follows.
